If you are renovating a single area of your home, you might be looking to do much of the work yourself. Whilst traditionally this might involve painting and decorating, there is no reason why you shouldn’t consider fitting the underfloor heating (UFH) yourself too – but it is important to choose the right system.
Here are 5 top tips for choosing a UFH system for DIY installation:
1.Consider the weight of the UFH system
It might seem a strange place to start, but the logistics of moving your UFH components where they need to be should not be overlooked. If you are tackling the installation yourself, you don’t want to waste time and effort lugging pallet loads of heavy components into the right part of the house. Choose a lightweight system and your back will thank you.
There’s an old adage that says ‘if you buy cheap, you pay twice’. This doesn’t mean that you need to buy the most expensive UFH system that you can find, but it does mean that you should choose a quality product that will save you both time and money in the long run.
3.Opt for a low-profile system
When you are renovating a property and fitting UFH over the existing floor, it is important to choose a low-profile system that minimises any disruption to fixtures and fittings. Some systems add as little as 15mm total height build-up.
4.Ditch the screed for a quicker, easier install
Choosing a completely dry UFH system avoids the need to call in specialist screeding contractors, and also means there is no waiting around for the compound to dry. Floor coverings can then be fitted immediately.
5.Choose a system with pre-routed channels for the tube
Make life easier for yourself by choosing a UFH system where the channels for the tube are already in place. Pre-routed panels and boards make it straightforward to run the tube around the room and back to the manifold, changing direction when needed. They also hold the tube securely in place.
LoPro®Lite – the ideal DIY UFH solution
Lightweight, low-profile, versatile and completely dry, LoPro®Lite is a retrofit UFH system that has been designed to be easy to install. The latest addition to Nu-Heat’s award-winning LoPro® range, LoPro®Lite is available as both a designed whole-house system and a high-quality OneZone® kit for single rooms or areas.
LoPro®Lite consists of pre-routed, high-density EPS (expanded polystyrene) boards which have an excellent point-load strength, and add just 15mm (the height of a 5p coin) to the existing floor level before the floor deck. Diffuser plates sit in the straight sections of the boards to enhance heat distribution from the 10mm FastFlo® tube, and a standard chipboard deck is laid over the top of the panels and UFH tube before floor coverings are fitted.
Get in touch
Call 01404 549770 or firstname.lastname@example.org to discuss UFH solutions for your home.